Search By Part Number	Straight Accessories 90° Accessories 45° Accessories Miscellaneous Accessories Support Data/ Assembly Procedures   Descriptions SE1 SE2 SE3 SE4 SE5 SE6 SE7 SE8 SE9 SE10 SE11 SE12 SE14 SE16 SE17 SE18 SE19 SE20 SE22 SE25 SE26 SE27 SE28 SE29 SE30 CLICK HERE TO VIEW A LARGER IMAGE EXAMPLE BASIC PART NUMBER click here for SERIES CODE INFORMATION
SERIES CODE C MAX DIM A .875 B .875 C .781 D .500 E .750 F .438 FM .438 G .750 H 1.125 J .375 K .531 KA .281 KB .312 KC .250 KD .406 L .531 M .531 N .375 P 1.250 R .781 T .656 W .500 X .438 U .875      ENTRY SIZE D MAX DIA E MAX DIA CABLE ENTRY MAX MIN 02 .840 .781 .250 .125 03 .965 .906 .375 .156 04 1.090 1.031 .500 .281 05 1.215 1.156 .625 .406 06 1.340 1.281 .750 .531 07 1.465 1.406 .875 .656 08 1.590 1.531 1.000 .781 09 1.715 1.656 1.125 .906 10 1.840 1.781 1.250 1.031 11 1.965 1.906 1.375 1.156 12 2.090 2.031 1.500 1.281 NOTES: Identified Per MIL-STD-130 Plating Index for Finishes Available Length to be specified by customer .5 inch increments (2.0 minium length consult factory for availability of shorter lengths). Material; Adapter Components; Aluminum Alloy Per QQ-A-225 or QQ-A-591. Elastomers, Standard Neoprene Per MIL-R-3065 or Silicone (See Note 5) Per ZZ-R-765. Insert letter: 'S' for Silicone elastomers. 'N' for non-environmental (o-ring not supplied) (omit letter for standard neoprene) Insert letter: 'N' for non-RFI. (spring not supplied) Insert letter: 'C' for nut (no strain relief); (omit for strain relief clamp) Insert letter: 'C' for chain attachment. (omit if not required) When entry size exceeds connector barrel ID two piece sleeve will be supplied. Insert the letter 'R' after series code designator to obtain spin coupling. Available on Series Codes C,F,FM,G & U only. (limited seal on F) SE97-***-* ground support ring (ordered sperately is recommended for all rfi assemblies and when shield support ring must be used for sufficient grounding. (see SE97) DIMENSIONS ARE IN INCHES Tolerance, unless otherwise specified: .X ± .03 (1.5) .XX ± .010 (0.8) .XXX ± .005 (0.4) Angles: ± 5 degrees Fractions ± 1/32 Click here for this part's assembly procedure (AP27) AND Click here for this part's assembly procedure (AP28)