Search By Part Number	Straight Accessories 90° Accessories 45° Accessories Miscellaneous Accessories Support Data/ Assembly Procedures   Descriptions Plating Index, Torque Values Crimp Ring Data Chart Military to Commercial Part Number Reference Chart. Spin Coupling Data AP2 AP3 AP6 AP7 AP9 AP10 AP16 AP27 AP28 AP95 AP463 AP28840 CLICK HERE TO VIEW A LARGER IMAGE
SUGGESTED PROCEDURE Temporarily assemble item 1* to connector. Insert cable into item 1* and bottom on connector. Mark jacket at rear of item 1 or 1b. Disassemble connector from item 1* slide adapter components up cable away from termination area so as not to interfere with subsequent assembly steps. Trim cable jacket at mark (ref. step 2) being carful no to cut overall shield. Terminate conductors in accordance with normal practices. Slide item 1* down cable and thread securely to connector. Slide first RFI ring down cable and seat into bore at rear of item 1. Flair shielding out over the periphery of first RFI ring and trim off excess. Slide second RFI ring down cable and press into place over first RFI ring, securing shield and seating o'ring (if applicable). Slide cable clamp down cable and thread securely to rear of item 1*. This will seat RFI rings in grounding position and seal the cable jacket (if applicable). Additional tightening of the assembly may be obtained by the use of a trap wrench or by using the wrench falts or knurls afforded. NOTE: Elastomers should be lubricated prior to assembly to avoid damage and insure proper sealing. * 45° & 90° assembly, item 1 includes adapter (item 1a) and elbow (item 1b) sub-assembled. (90° shown)