Search By Part Number	Straight Accessories 90° Accessories 45° Accessories Miscellaneous Accessories Support Data/ Assembly Procedures   Descriptions Plating Index, Torque Values Crimp Ring Data Chart Military to Commercial Part Number Reference Chart. Spin Coupling Data AP2 AP3 AP6 AP7 AP9 AP10 AP16 AP27 AP28 AP95 AP463 AP28840 CLICK HERE TO VIEW A LARGER IMAGE
The following is suggested procedure for individual shield & armor braid termination with environmental seal. (It is recommended that actual samples of appropriate cable be used to determine exact dimensions). Temporarily assemble item 1* to connector. Insert cable into item 1* & bottom on connector. Mark armor braid 3/4 inch behind item 1*. Dissassemble item 1* from connector. Slide all items up able in sequence shown excepting items 2 & 3 (RFI rings). Cut armor braid at mark. Cut cable jacket 2-1/4 inches forward of armor shield (see detail). Prepare individual shields in accordance with Sunbank assembly procedure AP95. Slide item 3 on cable. Flare out individual shields, slide item 2 on cable & capture shields between items 2 & 3 secure with screws trim shields if necessary. Terminate conductors in normal practice. Individual shield termination should be no more than 1 inch behind connector insert. (Shrink sleeving may be placed over RFI rings for isolation feature). Slide item 1* down cable & tighten securely to connector. Slide gland and ring into item 1*. Force armor braid back 3/4 inch. Tape to secure if needed. Engage rear adapter to item 1* & tighten securely. Slide armor forward & flare over adapter cone. Slide ground ring into place over braid & trim excess braid strand if necessary. Engage cable clamp tighten securely to rear adapter. Tighten clamp saddle bars around armor braid. * 45° & 90° assembly, item 1 includes adapter (item 1a) and elbow (item 1b) sub assembled. (90 shown).