Search By Part Number	Straight Accessories 90° Accessories 45° Accessories Miscellaneous Accessories Support Data/ Assembly Procedures   Descriptions Plating Index, Torque Values Crimp Ring Data Chart Military to Commercial Part Number Reference Chart. Spin Coupling Data AP2 AP3 AP6 AP7 AP9 AP10 AP16 AP27 AP28 AP95 AP463 AP28840 CLICK HERE TO VIEW A LARGER IMAGE
SUGGESTED PROCEDURE Temporarily assemble Item 1 to connector. Slide reamaining components on cable in sequence shown. Keep these components away from termination, so they will not interfere with subsequent assembly steps. Insert cable thru Item 1 and bottom on connector. Mark cable while in position at the rear end of sleeve. Remove Item 1 from connector and slide up cable along with other components. Trim cable (jacket if applicable) approx. 3/4 to 1/2 inches behind mark made in Step 3. * NOTE: Slide SE97 support ring (if applicable) under shield to end of cable jacekt. Prepare and terminate conductors in accordance with normal practices. Slide Item 1 and tighten securely to connector. Slide the spring into place along with second sleeve and tighten securely. This will insure a positivce 360° grounding of the shield. Slide down and tighten cable clamp. Place saddle bars around cable and tighten, being careful not to damage cable. Inspect final assembly for proper installation. Note: Elastomers should always be lubricated prior to assembly to avoid damage and insure proper sealing (if applicable).