Search By Part Number	Straight Accessories 90° Accessories 45° Accessories Miscellaneous Accessories Support Data/ Assembly Procedures   Descriptions Plating Index, Torque Values Crimp Ring Data Chart Military to Commercial Part Number Reference Chart. Spin Coupling Data AP2 AP3 AP6 AP7 AP9 AP10 AP16 AP27 AP28 AP95 AP463 AP28840 CLICK HERE TO VIEW A LARGER IMAGE
SUGGESTED PROCEDURE Slide cable clamp and ground ring up cable. Temporarily assemble item #1* (compression ring, if applicable) to connector. Insert cable into item 1* and bottom on connector. Mark and trim cable jacket approx. 1/2 inch behind sleeve. Disassemble item 1* from connector and slide up cable with other components. Prepare individual or overall shield by flaring out or flatten and secure against the outer periphery of the cable or harness. Slide item 1* (compression ring if applicable) forward and thread onto connector. Tighten securely. Flare or comb shielding out over and around ground ring and secure with spot tie, as shown, see detail. Slide ground ring into place in tapered bore, at rear of sleeve. Slide clamp down and tighten on sleeve with approx. 35 inch lbs. This will insure a positive 360° grounding of the shielding and also provide a strain relief for cable or harness. * Item 1, 90° assembly includes: elbow (item 1a) cap (item 1b) and sleeve (item 1c) sub-assembled.